Nilfisk VP100 Bedienungsanweisungen Seite 6

OPERATING INSTRUCTIONS
Instruction:
 This machine is typically used in hotels,schools,offices, hospitals and commercial buildings
 This manual should be read thoroughly before operation.
 Please use the recommended accessories when operating the machine.
Before operating this machine:
 Make sure that all components including cable, plug and switch, are in good working order and
ensure that the operation voltage is in accordance with the required voltage rating of the
machine.
Description of the construction of the device. For parts diagrams of construction,
refer to "F1" Diagram on page 3.
1. Power cord, 2. Latch, 3. Rear wheel, 4. Handle, 5. Power switch, 6. Logo, 7. Hose connection, 8.
Caster wheel, 9. Serial number label, 10. Exhaust cover, 11. Exhaust filter sponge,
12.Accessory storage
pre filter (cotton), 16. Main filter basket, 17. Dust bag, 18. Container, 19. Inlet, 20. Adapter
coupling, 21. Suction hose connector, 22. Suction hose, 23. Bent end, 24. Pressure regulator, 25.
Hard/soft floor switch, 26. Combination nozzle, 27. Steel tube, 28. Dusting tool, 29. Crevice tool
Remark: the parts or accessories are subject to change without prior
Operating instructions
1. Please use the recommended dust bag. Insert the latex ring of dust bag into the suction hose
inlet of container and place dust bag flatly into the container.
2. Place the main filter basket onto the dust tank with dust bag inside. (Note: the main filter
basket can only be fitted in one direction. T
rear of the machine)
3. Place the motor head onto the container, then lock the two side latches to secure the unit.
(Locking latch can be referred to picture"F2 A", releasing the latches can be referred to in picture
"F2 B").
4. Screw the adapter connection onto the container inlet (refer to picture "F3 A"). Then insert the
suction hose into the adapter and twist clockwise to secure (refer to picture "F3 B").
5. Plug power cord into the mains socket, press the blue power switch to start the machine 6.
When stopping the machine, again press the blue power switch one time.
13. Combination tool storage position, 14. Motor head assembly, 15. Motor
he side with the word
6
ENGLISH
notice.
"Back" should be placed at the