Avtek Tension Gebrauchsanweisung Seite 9

No matter which method you choose to install, the following methods are the same.
A. Lift the screen to the top of the wall mount until
the slot of the screen meet the top tray as the picture showed.
B. As the picture showed, push the screen into the mount horizontally, the
slip hook will be press down first, then then rise up to the slot of the screen
under the function of the spring, that can prevent the screen from falling off
or turning to one side.
Slant of the slide hook
C. There are two set of ring-pulls on each side of the screen, when the user need to dismount the screen: two person hold
the screen on each side, pull down the ring so that the hook detach from the slot, and then push the screen off the wall
mount horizontally. It is quite easy to dismount the screen. As the picture C showed.
Please note that it must be dismounted by professional person. Nonprofessional dismount will easily break the screen. If
you need maintenance, please contact the distributor.
The tightness adjustment of the strings
The strings have adjusted to its perfect place before it was sold out from factory, but
for the factors of transportation and long time use. The surface will has some slight
changes. In order to make sure the flatness of the screen, some adjustments needed.
The methods are as the picture showed:
Spring
Sphere
B
Slant of the slide hook
Sphere
Spring
Ring-pull
C
Sphere
Top tray of the mount
The slot on the house
A
7