Avtek Tension Gebrauchsanweisung Seite 8

1. The method of wall installation
As the picture showed, measure and draw contour line
on the wall to make sure the wall mount level. Make the
upper side of the wall mount meet the contour line. Hold
it and draw a circle on the wall through the install hole to
make sure the point of the expansion bolt. Take away
the wall mount and drill a hole to install the expansion
bolt on the center of the circle. Install the wall mount
through the expansion bolt and screw the nut. Use the
leveling instruments to make sure the level of the wall
mounts, and then draw a circle on the other side of the
wall mount, drill and install the other expansion bolt.
Install the wall mount through the two expansion bolt,
then screw the nuts and fixed the mount on the wall.
Install the other wall mount on the same way. The
method to install the screen showed below.
2. The method of ceiling installation
Make sure that the ceiling can support 50kg.
As the picture showed, measure and draw lines for
reference to make sure the two mounts on the same level,
install the mount on the ceiling and make sure the back
side of the mount meet the line. Draw two circles through
the installation holes, drill two holes according to the
circles for the expansion bolts with the percussion drill.
Install the mount on the ceiling through the expansion
bolts and screw the nuts, then the mount fixed on the
ceiling.
Install the other mount in the same way. The method to install the screen showed below.
3. The method of overhang
As the picture showed, take out the lifting nut from the
accessory case and install it on the wall mounts. Install
Installation hole 1
the sling chain on the ceiling. Put the ring of lifting nut to
Lifting nut
the hook of the sling chain.
The method to install the screen are the same with wall
and ceiling installation, as below showed.
6