Adjusting The Pinlock ® Lens Tension; Installing The Pinlock ® Lens; Acoustic Damping; Front Vent - Crivit 292222 Bedienungsanleitung

The cheek pads are affixed via three press-studs
respectively in the helmet . You can easily remove
the pads . The thicker cheek pads can now also
be affixed in the helmet with three press-studs .
You need to be able to hear that each press-stud
locks-in .
Acoustic Damping (Fig. H)
The acoustic damping (13) is for noise reduction,
in particular when driving at high speeds .
Press the acoustic damping into the cavity of the
cheek pads . The acoustic side pad equipped
with Velcro faces towards the helmet shell .
Front Vent (Fig. I)
The front vent (6) can be opened and closed via
toggle .
Top Vent (Fig. J)
The top vent (1) can be opened and closed by
means of a slider .

Winter Collar

To reduce the wind inlet at the bottom of the hel-
met during periods with very cold temperatures,
the pre-installed standard collar (16) can be
replaced with the supplied winter collar (17) .
Removing the standard collar (Fig. K)
Pull the one-piece standard collar towards the
inside of the helmet at the middle of one side .
Inserting the Winter Collar (Fig. L)
Insert the rod of the winter neck roll into the open-
ing on one side of the helmet . Fix the neck roll
almost completely . Insert the second rod into the
opening in the helmet and push in the remainder
of the neck roll .

Visor Replacement

A damaged or severely scratched visor (8) can
be replaced with a replacement visor .
Removal of the Visor
• Slide the visor into the highest position (fully
opened) (Fig . M) .
• Pull the visor-locking lever and remove the visor
(Fig . N) .
Inserting the Visor
• Place the replacement visor on the hold-down
device and observe the correct positioning in
the process (fully opened) (Fig . M) .
• Pull the visor-locking lever and place the visor
appropriately (Fig . O) .
• Allow the replacement visor to snap in and
close the visor .
Installing the Pinlock
Remove the helmet visor . Bend the visor and
place the Pinlock lens between the two pins on
®
the helmet visor (Fig . P-Q) . Allow the helmet visor
to return to its original shape . The silicone seal
on the Pinlock lens must make full contact with
®
the helmet visor to prevent condensation (Fig . R) .
Remove the protective film from the Pinlock
Reattach the helmet visor to the helmet .
Adjusting the Pinlock
Remove the Pinlock lens . To adjust the pins, push
®
the pins outward, turn with your fingers and push
back in (Fig . S) .
Selecting the Correct
Helmet Size
• Measure the circumference of your head and
select the helmet size based on this measure-
ment . Try out several helmets before deciding .
Ideally, the skin on your temples will move
along when wearing the helmet .
• Ensure that even without the chin strap secured,
the helmet does not move much on your head .
• The chin strap must be closed firmly for a se-
cure fit . It is fitted correctly if it is difficult to slide
your fingers under the chin strap . However, you
must still be able to comfortably breathe, swal-
low and turn your head .
• Verify the helmet was tested according to the
latest ECE standard .
lens
®
lens .
®
lens tension
®
GB 17