Winter Collar; Visor Replacement; Selecting The Correct Helmet Size; Maintenance And Care - Crivit 272277 Bedienungsanleitung

Winter Collar

To reduce the wind inlet at the bottom of the hel-
met during periods with very cold temperatures,
the pre-installed standard collar (14) can be
replaced with the supplied winter collar (15) .
Removing the standard collar
Pull the one-piece standard collar out of the
helmet (see Fig . J) .
Inserting the Winter Collar
First attach the plastic clip in the centre at the
back part of the helmet in the groove between
the outer shell and the padding .
Once the plastic clip is completely locked, press
the complete winter collar again firmly onto the
padding of the helmet (see Fig . K) .

Visor Replacement

If the pre-mounted visor (7) is damaged or
severely scratched, you can exchange it with the
replacement visor .
Removal of the Visor
• Slide the visor into the highest position (fully
opened) (see Fig . L) .
• Pull the visor-locking lever and remove the visor
(see Fig . M) .
Inserting the Visor
• Place the replacement visor on the hold-down
device and observe the correct positioning in
the process (fully opened) (see Fig . L) .
• Pull the visor-locking lever and place the visor
appropriately (see Fig . N) .
• Allow the replacement visor to snap in and
close the visor .
Selecting the Correct
Helmet Size
• Measure the circumference of your head and
select the helmet size based on this measure-
ment . Try out several helmets before deciding .
Ideally, the skin on your temples will move
along when wearing the helmet .
• Ensure that even without the chin strap secured,
the helmet does not move much on your head .
18 GB/MT
• The chin strap must be closed firmly for a
secure fit . It is fitted correctly if it is difficult
to slide your fingers under the chin strap .
However, you must still be able to comfortably
breathe, swallow and turn your head .
• Verify the helmet was tested according to the
latest ECE standard .
Size table
Size Head circumference
M
L
XL

Maintenance and Care

Regular maintenance and care contributes to
safety and maintaining the helmet .
Cleaning of the Helmet
• Never use solvents, petrol or other detergents
when cleaning the shell and interior of your
helmet .
• Always use pH-neutral detergent dissolved in
clean water . Careful rub with a soft cloth . Then
wipe dry with a lint-free cloth .
Visor care and cleaning
• After using the helmet, lightly wipe off any
grime (e .g . dead insects, dirt, sand, dust etc . )
from the visor with a soft cloth and then fully
wipe it clean using a dry soft cloth .
• When the visor gets wet (e .g . rainwater) it
should always be wiped with a soft cloth .
• When cleaning the visor, never use any petro-
leum-based solvents or detergents containing
abrasives .
57 – 58cm
59 – 60cm
61cm