5.2
Startup and Shutdown
Proper startup and shutdown procedures are crucial to expanding the life of the DVR.
To start your DVR:
Steps:
1.
Check the power supply is plugged into an electrical outlet. It is HIGHLY recommended that an
Uninterruptible Power Supply (UPS) be used in conjunction with the device.
2.
Press the POWER button on the front panel. The Power LED should turn green. The unit will begin to start.
After the device starting up, the wizard will guide you through the initial settings, including modifying
password, date and time settings, network settings, HDD initializing, and recording.
To shut down the DVR:
1.
Enter the Shutdown menu.
Menu > Shutdown
2.
Select the Shutdown button.
3.
Click the Yes button.
4.
Turn off the power switch on the rear panel when the following message pops up.
© Vanderbilt 2017
Figure 5-2 Shutdown
Figure 5-3 Power off
Menu Operation
16