Klarstein 10030104 Bedienungsanleitung Seite 13

• The aooliance is not designed for commercial use. It is intended for use in domestic households and in simi-
lar working and residential environments.
• Power cord must not be lengthened.
• Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or
damaged power plug may overheat and cause a fire.
• Make sure that you can come to the mains plug of the appliance. Do not pull the mains cable.
• If the power plug socket is loose, do not insert the power plug. There is a risk of electric shock or fire.
• You must not operate the appliance without the lamp.
• Do not remove nor touch items from the freezer compartment if you hands are damp/wet, as this could
cause skin abrasions or frost/freezer burns.
• Avoid prolonged exposure of the appliance to direct sunlight.
Hints on Use
• Do not put hot on the plastic parts in the appliance.
• Do not place food products directly against the rear wall. Frozen food must not be re-frozen once it has been
thawed out. Store pre-packed frozen food in accordance with the frozen food manufactures instructions.
• Do not place carbonated of fizzy drinks in the freezer compartment as it creates pressure on the container,
which may cause it to explode, resulting in damage to the appliance.
Hints on Cleaning
• Before maintenance, switch off the appliance and disconnect the mains plug from the mains socket.
• Do not clean the appliance with metal objects.
• Do not use sharp objects to remove frost from the appliance. Use a plastic scraper.
• Regularly examine the drain in the refrigerator for defrosted water. If necessary, clean the drain. If the drain
is blocked, water will collect in te bottom of the appliance.
Hints on Installation
• Unpack the appliance and check if there are damages on it. Do not connect the appliance if it is damaged.
Report possible damages immediately to the place you bought it. In that case retain packing.
• It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the
compressor.
• Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve suffici-
ent ventilation follow the instructions relevant to installation.
• Wherever possible the spacers of the product should be against a wall to avoid touching or catching warm
parts (compressor, condenser) to prevent possible burn.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
Hints on Repairs
Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician
or competent person. This product must be serviced by an authorized Service Center, and only genuine spare
parts must be used.
13