Installation - EuroLite LED TMH-46 Bedienungsanleitung

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
Screw a clamp via a M10 screw and self-locking nut onto the omega-holder. Insert the two screws of the
enclosed omega-holder by using a circlip for each screw into the respective holes on the bottom of the
device. Tighten the screws fully. In order to secure the device via the omega-holder with a safety bond
you always need circlips for installation, one for each screw.
4 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Pull the
safety bond through the omega holder t and fasten it in such a way that, in the event of a fall, the
maximum drop distance of the device will not exceed 20 cm.
5 After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
20/28 00113093, Version 1.0