Preparing Milk Froth And Warm Milk; Dispensing Hot Water - Siemens TE 809F-Serie Gebrauchsanleitung

Preparing milk froth and
warm milk
¡ Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting Milk froth or
Warm milk by turning the rotary knob 6.
● Press the start button 8.
Milk froth or warm milk flows from the outlet
of the milk frother 10.
Press the start button 8 again to cut the
process short.
Info: When preparing warm milk, you may
hear a whistling sound. This is caused by
the milk frother for technical reasons.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difficult
to remove, so the milk frother must be
cleaned with lukewarm water immediately
after use (see "Cleaning the milk system").
TE809F_MK.indb 41

Dispensing hot water

¡ Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting for Hot water
by turning the rotary knob 6.
● Press the start button 8.
Please remove suction hose ▶ start
● Remove the milk suction hose 10c and
press the start button 8.
Hot water runs out of the milk frother
outlet 10.
Press the start button 8 again to cut the
process short.
Note: It is possible to set the temperature of
the hot water (see "Menu settings").
en
41
08.05.2013 12:13:04