Preparation Using Ground Coffee; Preparing Milk Froth And Warm Milk - Siemens TE803 Serie Gebrauchsanleitung

en
Preparation using
ground coffee
This fully automatic espresso machine can
also be operated using ground coffee (not
instant coffee powder).
Note: The aromaDouble Shot function
cannot be used when coffee is prepared
using ground coffee.
Drink preparation without milk
The appliance must be ready for use.
● Place the pre-warmed cup(s) under the
coffee outlet 9.
● Select the required
Á
by turning the rotary knob 6.
Coffee
● Open the powder compartment 18.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
¡ Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment 18.
● Press the start button 8.
The coffee is brewed and then dispensed
into the cup(s).
Note: Repeat the procedure for another cup
of coffee. If coffee is not dispensed within
90 seconds, the brewing chamber emp-
ties automatically to avoid an overflow. The
appliance rinses.
Drink preparation with milk
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Swivel the coffee outlet 9 to the right until
it clicks into place.
● Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
● Select the required
Cappuccino
Æ
knob 6.
42
À
or
Espresso
or
Macchiato
Å
by turning the rotary
● Open the powder compartment 18.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
¡ Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment 18.
● Press the start button 8.
First milk is delivered into the cup or glass.
Then the coffee is brewed and dispensed
into the cup or glass.
Important: Dried milk residue is difficult
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see "Cleaning the milk system").
Note: Repeat the procedure for another
cup of coffee / milk drink. If coffee is not
dispensed within 90 seconds, the brewing
chamber empties automatically to avoid an
overflow. The appliance rinses.
Preparing milk froth and
warm milk
¡ Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting
or
Warm milk
É
knob 6.
● Press the start button 8.
Milk froth or warm milk flows from the outlet
of the milk frother 10.
Press the start button 8 again to cut the
process short.
Milk froth
by turning the rotary
È