Funkey DP-88 II Bedienungsanleitung Seite 28

Precautions / Please read carefully before proceeding
Always follow the basic precautions listed below to avoid the possibility of serious injury
or even death from electrical shock, short-circuiting, damages, fire or other hazards.
Power supply / power cord (devices with power cords/power supplies):
Only use the voltage specified as correct for the device. The required voltage is printed
on the type plate of the device. Check the power cable from time to time regarding dirt,
damage or other influence. Use only the included power cord / power supply or adaptor.
Do not place the power chord near heat sources such as heaters or radiators, and do
not excessively bend or otherwise damage the cord, place heavy objects on it, or place
it in a position where anyone could walk on, trip over, or roll anything over it. Remove
the electric plug from the outlet when the device is not to be used for extended periods
of time, or during electrical storms. When removing the electric plug from the device or
an outlet, always hold the plug itself and not the cord. Pulling by the cord can damage
it. To avoid generating unwanted noise, make sure there is adequate distance (50 cm
or more) between the AC power adaptor and the device. Do not cover or wrap the AC
power adaptor with a cloth or blanket.
Location:
When setting up the device, make sure that the AC outlet you are using is easily
accessible. If some trouble or malfunction occurs, immediately turn off the power switch
and disconnect the plug from the outlet. Even when the power switch is turned off,
electricity is still flowing to the product all the minimum level. When you are not using
the product for a long time, make sure to unplug the power cord from the wall AC outlet.
Inadequate ventilation can result in overheating, possibly causing damage to the
device(s), or even fire Do not expose the device to excessive dust or vibrations, or
extreme cold or heat (such as in direct sunlight, near a heater, or in a car during the day)
to prevent the possibility of panel disfiguration or damage to the internal components.
Do not place the device in an unstable position where it might accidentally fall over. Do
not block the vents. This device has ventilation holes at the bottom/rear to prevent the
internal temperature from becoming too high. In particular, do not place the device on
its side or upside down. Inadequate ventilation can result in overheating, possibly
causing damage to the device(s), or even fire. Do not use the device in the vicinity of a
TV, radio, stereo equipment, mobile phone, or other electric devices. Doing so may
result in noise, both in the device itself and in the TV or radio next to it.
Connections and handling:
Before connecting the device to other devices, turn off the power for all devices. Before
turning the power on or off for all devices, set all volume levels to minimum. Do not use
the device or headphones for a long period of time at a high or uncomfortable volume
level, since this can cause permanent hearing loss. If you experience any hearing loss
or ringing in the ears, consult a physician. Do not rest your weight on the device or place
heavy objects on it, and avoid use excessive force on the buttons, switches or
connectors. Do not open the device or attempt to disassemble the internal parts or
modify them in any way. The device contains no parts where the user can do service. If
it should appear to be malfunctioning, discontinue use immediately and have it inspected
by qualified service personnel.
English User manual
27