Specifications - Stihl TSA 230 Gebrauchsanleitung

Specifications

Battery
Type: Lithium-Ion
Designation: AP
The machine may be operated only with
original STIHL AP rechargeable
batteries.
Running time is dependent on the
energy content of the battery.
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Max. spindle speed:
Outside diameter:
Max. thickness
Bore diameter/spindle
diameter:
Tightening torque:
Composite resin abrasive wheels
Minimum outside diameter
of thrust washers:
Max. depth of cut:
TSA 230
Diamond abrasive wheels
Minimum outside diameter
of thrust washers:
Max. depth of cut:
Weight
without battery, without
abrasive wheel, with water
connection
Water supply
Max. pressure of water
supply:
Sound and vibration levels
For further details concerning
compliance with the Physical Agents
Directive Vibration 2002/44/EEC, see
6650 rpm
www.stihl.com/vib/
230 mm
(9 ")
Values when cutting concrete under
3 mm
pressure with diamond abrasive wheel
22.23 mm
Sound pressure level
(7/8 ")
L to EN 60745-2-22: 103 dB(A)
20 Nm peq
Sound power level L
(177 lbf. in.)
EN 60745-2-22:
Vibration level a
80 mm
EN 60745-2-22:
(3.150 in.)
Left handle:
70 mm
Handle, right
(2.756 in.)
80 mm
(3.150 in.)
70 mm
(2.756 in.)
3.9 kg
(8.6 lbs.)
4 bar
(58 psi)
to
w
114 dB(A)
to
hv,eq
2
3.5 m/s
2
3.5 m/s
Values when maximum engine speed
without load with diamond abrasive
wheel
Sound pressure level
L to EN 60745-2-3: 93 dB(A)
peq
Sound power level L to
w
EN 60745-2-3: 104 dB(A)
Values when maximum engine speed
without load with composite resin
abrasive wheel
Sound pressure level
L to EN 60745-2-3: 72 dB(A)
peq
Sound power level L to
w
EN 60745-2-3: 83 dB(A)
The vibration values quoted above have
been measured according to a
standardized test procedure and may be
used to compare electric power tools.
Depending on the type of usage, the
vibrations that actually occur may differ
from the values quoted.
The vibration values quoted may be
used for an initial assessment of the
user's exposure to vibrations.
The actual exposure to vibrations has to
be evaluated. This process may also
take into account times during which the
electric power tool is switched off and
times during which it is switched on but
running without load.
Observe measures to reduce vibration
exposure to protect the user – see
section on "Vibrations" in chapter on
"Safety Precautions and Working
Techniques".
The K-factor in accordance with
Directive 2006/42/EC is 2.0 dB(A) for
the sound pressure level and sound
English
69