Werbung
ATTENTION: Batteries and rechargeable batteries in your transmitter should always be fully charged!
Never use the model when they are completely empty. Why? The transmitter could switch itself off, the
signal would be lost to your RC Model and it could have a mind of its own.
- this could be very expensive!
Getting Started:
Switch on transmitter, hold vehicle clear of the ground, connect battery pack and switch on receiver. Test
the transmitter to check control of the vehicle with wheels off the ground. Start driving slowly and if the
vehicle does not go straight, adjust steering trim dial on Transmitter. For the very first run use the throttle
gently, to help the driver become accustomed to the vehicles behaviour and controls
Always keep in mind:
!
"
This is NOT a toy and must be operated with caution and common sense. Failure to operate this
product in a safe and responsible manner could result in damage, injury or damage to other
property
If you switch on the car first, before the transmitter your RC Model could have a mind of its own and
could drive off.
You shouldn't drive your model through big puddles unnecessarily. The vehicle is not designed to be
completely submerged in water.
but are not water proof. Components like the motor are only splash proof. Most of all you should take
care of the plug connections.
#
Your RC models is designed to take some rough and tumble and moderate pumps, please bare in mind
the bigger the pump the more likely you could damage your RC vehicle.
General information
Please observe:
#
Driving in wet conditions:
The components of Absima and Team C RC Models are water resistant
Jumps:
Werbung
