Bose PackLite A1 Bedienungsanleitung Seite 7

English Dansk
Top panel indicators
The top panel of the A1 has two indicators that tell you the state
of the amplifier.
Figure 3
A1 top panel
Signal indicator:
GREEN when a signal is present at the
input.
RED when amplifier is over-driven and
limiting function is activated to prevent
damage to the connected loudspeaker.
Setting up a single A1
The A1 amplifier is designed to add more bass output to a system
that already has two B1 bass modules connected to the Amp 3
OUT connector on the PS1 power stand. The A1 amplifier can
power up to two additional B1 bass modules.
Follow these steps to set up the A1 as shown in Figure 4 on
page 8.
1.
2.
3.
4.
5.
Deutsch Español
Connect the AC power cord to an AC (mains) outlet.
Make sure the A1 amplifier Power switch is OFF.
Using the supplied ¼" TRS cable, connect the Bass-Line
OUT connector on the PS1 power stand to the INPUT
connector on the A1 amplifier.
Connect a B1 bass module cable from the OUTPUT
connector on the A1 to a B1 bass module. If desired,
connect a second B1 to the first B1.
Set the A1 power switch to ON (I).
Français Italiano
P L TM P
ACK ITE OWER
Power indicator:
BLUE when amplifier
is on and ready to
use.
Nederlands Svenska
A M
MPLIFIER ODEL
A1
7