Safety Guidelines; Replacement Parts; Scope Of Application - Honeywell D05F Einbauanleitung

5.2 Maintenance
Frequency (1-3 years according to DIN 1988)
depends on local operating conditions.
The following should be carried out by
competent personnel, with the time interval
depending on the site conditions:
1. Close valve 1 .
2 Release pressure at side of outlet (e.g.
through water tap).
3. Loosen slotted screw 3 .
G do not remove!
4. Slacken spring tension
G
Turn adjusting knob 5 to the left (-).
5. Close valve 2 .
6. Remove spring hood
G using double ring spanner ZR06K.
➯ Accessory
7. Remove slip ring 6 .
8. Remove valve insert with a pair of pliers.
G
Check if sealing ring, nozzle side and
slotted ring are in good condition
G Clean filter
G Replace faulty parts.
9. Reassemble in reverse order
G press in membrane with finger before
inserting slip ring.
10. Adjust outlet pressure as described
under section 3 .

6. Scope of application

Medium
Inlet pressure
Outlet pressure
Temperature
EN 1567
*As part of an installation being approved according to PED
requirements, this product must also be certified.
Water, compressed
air*, nitrogen*
Maximum 25 bar
(350 PSI)
1.5 to 6.0 bar
(21 to 85 PSI)
Maximum 70 °C
GB

7. Safety guidelines

1. Use appliance:
G
In good condition
G
According to regulations and codes
of practise
G With due regard to safety.
2. Follow installation instructions.
3. Immediately rectify any malfunctions
which may influence safety .
4. D05F pressure reducing valve is
exclusively for use in applications
detailed in these installation instructions.

8. Replacement parts

Spring bonnet complete
0901515
Valve insert
D05FA- 1 / B
2
Spare filter
ES05F- 1 / A
2
Blanking plug with O-ring
S06K- 1 /
4
9. Accessories
Pressure gauge
M39K-A4
M39K-A10
ZR06K
Double ring wrench
VST06
Connection set
A = with tailpieces
B = with soldering connections
5
1 3
/ " + / "
2 4
1 / " + 3 / "
2 4
1 / " + 3 / "
2 4
1 / " + 3 / "
2 4
0 - 4 bar
0 - 10 bar