Mounting The Base - Bosch FRP-O3000 Bedienungsanleitung

FERION 3000 O
5.1

Mounting the base

1
1
2
3
4
1. Remove the base by unscrewing it counterclockwise from
the detector head.
2. Hold the base onto the ceiling to mark the standard
positions (1) for the drill holes. Make sure that the yellow
dot (2) points to the escape route.
3. Drill two fixing holes, insert the dowels and then use the
screws to mount the base.
4. Alternatively, you may wire the detectors. In this case, use
the appropriate fixing holes (3) and the two supplied
spacers to create a gap between the ceiling and the base.
5. Another option is the mounting with an installation box. In
this case, you may use the standard fixing holes (1).
Bosch Sicherheitssysteme GmbH
Standard fixing holes (may be used also with an
installation box)
Yellow dot for aligning the emergency light
Fixing holes when using spacers for wiring (optional)
Red triangle for aligning the detector head with the
base
User Guide
2
3
4
2013.01 | 3.0 | F.01U.249.483
Safety | en
23