Technical Data Sticker; Warranty Conditions; Disposal - Lavor Skyvap Anweisungen

FAILURES
•DANGER! Repairs must be carried out only by
an Authorized Service Centre.
NOTE: Failures may occur even when using
the machine properly. The table below
reports some failures and remedies. If these
instructions should fail, kindly apply to
an Authorized Service Centre for further
information.

TECHNICAL DATA STICKER

Check that technical data on the sticker correspond
to the ones of the electrical circuit to which you are
going to connect the machine.
Safety features: Service pressure switch • S e r v i c e
thermostat • Safety thermostat • Steam control on
the waterproof handle • Tamper-proof cap with
pressure release valve • Boiler in die-cast aluminium.
TECHNICAL DATA
Boiler volume
Boiler capacity
Operating temperature
Temperature during transport and storage
0÷40° C
Working room temperature
Arm vibrations
TECHNICAL DATA
See technical data plate:
Voltage / Frequency
Boiler draw rate
Failure
• The steam cleaner is ready to
work, but no steam comes
out.
• The flow of steam does not
come out regularly and
is accompanied by water
spray.
• When you work with the
steam cleaner, an accessory
comes off.
Steam pressure
Dimensions / Weight

WARRANTY CONDITIONS

All our machines are subjected to strict tests and
are covered against manufacturing defects in accor-
dance with applicable regulations. The warranty is
effective from the date of purchase.
The following are not included in the warran-
ty: - Parts subject to normal wear. - Rubber parts,
charcoal, filters and the accessories and optional
accessories. - Accidental damage, caused by tran-
sport, neglect or inadequate treatment, incorrect or
improper use and installation failing - The warranty
shall not cover any cleaning operations to which the
operative components may be subjected, such as
clogged nozzles and filter blocked due to limesto-
nes.
2,4 l
1,6 l
145° C
• The appliance and its accessories must be
0÷40° C
• Disposal must be carried out in accordance
< 2,5 m/s
2
• As owner of an electrical or electronic product,
V Hz
W
Cause
• The steam intensity regulator
(optional) is on position 0.
• The accessory is obstructed.
• The boiler has been filled with
too much water.
• The accessory has not been
connected properly.

DISPOSAL

• Disposal must be carried out in
accordance with applicable environmental
legislation.
disposed of in accordance with the materials used
in their construction.
with applicable local legislation. Contact your
municipality for the nearest refuse dumping site.
you are not allowed by law (according to EU-
Directive 2012/19/EU on waste electrical and
electronic equipment and the particular national
• Turn the steam intensity regulator
on position 1-5.
• Check the accessories.
• Press the lever (1) to drain the
excess water. Be careful not to
overfill the appliance (max 1.6
liter).
• Fit the accessory properly.
EN
kPa (bar)
Kg
Remedy
57