X-lite X-901 Gebrauchsanleitung Seite 25

7
8
9
Warning! Do not loosen the adjustment screws on the visor lock-
ing pins.
B) Turn the visor supports on the
side controls upwards with your
hand, to their maximum open-
ing position on both sides of
the helmet (Fig. 7).
1.5.1 - Place the visor end over
on the visor locking pins and
align the visor internal guides
with the supports provided on
the controls (Fig. 8).
1.5.2 - Push in the visor towards
the locking pin and, at the same
time, align the internal guides
with the control supports (Fig. 9).
1.5.3 - Push the visor back and
cause it to slide on its support
until the locking pin clicks into
the visor special hole and locks
the visor.
1.5.4 - Repeat these operations
1.5.1, 1.5.2 and 1.5.3 for the
other side of the helmet as well.
1.5.5 - Close the visor (see item
1.2) then open it again (see 1.1)
to check that the system works
correctly.
- 23 -