Accessories Included; Installing The Psu; Installation Diagram - Televes DINOVA BOSS Bedienungsanleitung

DINOVA BOSS
Features
7-element Yagi antenna (directional) with
Microstrip technology (EU patent) in UHF and
printed whip + telescopic elements extended
in VHF (BOSS MIX). BOSS-Tech technology,
activated when the antenna is powered, makes
the antenna to intelligently and automatically
be adjusted to the best level of output, providing
a high electrical performance.
It can also be used in passive mode (without
power), when the signal level received is enough
in the area.
The BOSS-Tech can also be powered by a battery
or other DC source (12-24V
injector).
Designed for the reception of Digital Terrestrial
Television and prepared to reject the mobile
interferences. The DINOVA BOSS antenna
receives all digital and HD channels available in
your area.
Developed with the innovative
technology, that improves the gain with very
estable reception and better coverage area.
Protected by a UV-resistant plastic dome
suitable for adverse weather
(humidity, water, wind, high temperatures, etc.).
Compact with a discreet design of low visual
impact suitable visual for installation in
balconies and single-family homes.
Easy installation thanks to the robust built-in
clamp.

Accessories included:

(figs. 1a & 1b depending on the reference):
1 Power supply unit
1 F type connector.
1 F watertight cover.
Installation
If possible, choose an installation point free from
obstacles, where the antenna can be pointed in the
direction of the transmitter (fig. 2).
If mounted on a mast, a diameter of between 35
) and a current
and 45 mm is recommended.
The antenna can be installed in horizontal or
vertical polarity thanks to the design of its clamp
(figs. 3 & 4).
Connect the antenna to the mast with the clamp in
the position shown. Twist the clamp down on the
screw so that it grips the mast firmly, and push it
TForce
into the other screw (fig. 4b).
Slide the clamp onto the screws until it grips.
Tighten the connecting bolts slightly so that
the antenna can then be turned towards the
conditions
transmitter (fig. 4c).
In models BOSS MIX, extend completely the
telescopic elements extended (fig. 5).

Installing the PSU

Choose an accessible point inside the room to
install the PSU so that it is protected from heat,
damp, etc., making sure that the length of the cable
from the antenna to the PSU is not too long (fig. 5).
The connection to the antenna is made using an "F"
connector (fig.6), while the PSU is connected using
an "EasyF" connector type.
Make sure that the cable is not wound round too
many times, and that it does not have any kinks.

Installation diagram

Use one of the diagrams shown in figures 8, 9 or 10
for installation.
IMPORTANT:
When the power injector is used, make sure that
the polarity of the power cables is correct, and
also make sure that the antenna is connected to
the output of the injector that provides voltage.
We recommend protecting the antenna's "F"
connection using the watertight cover provided
together with the antenna to prevent water from
entering (fig. 7).
12