Axis Q1602-E Installationsanleitung Seite 9

AXIS Q1602-E/AXIS Q1604-E Installation Guide
Notes:
• Using any other than the provided cable gland may cause water to seep in and damage the product.
• Always use a shielded network cable (STP) intended for outdoor use between the Axis product and
the end point and ensure that the end point is properly grounded. Installations of Axis products using
a shielded network cable (STP) and a properly grounded end point have been tested to comply with
industry immunity standards' levels such as surge protection. Any other installation method will void
the warranty and leave the unit at a risk.
• An optional cable with a diameter of 4.0 mm - 5.5 mm should be routed through a separate cable
Hardware overview
gland (see
Attach camera to the wall bracket
1. Place the camera with the bottom cover on the wall bracket and tighten the bracket screws.
2. Replace the cable cover and tighten the screws.
3. Connect the cables. See
4. Loosen the bracket adjustment screw to focus the camera; focus the camera according to the
instructions under
for information on how to view the video stream.
5. Attach the safety wire in the top cover to the tab in the bottom cover (see image under
Hardware overview
6. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images locally in
the camera.
).
Connect the cables,
Adjust zoom and focus,
).
on page 10.
Network cable (routed
through wall bracket)
Cable holes with cable gland
Bottom cover
Bracket screw (4x)
Cable cover
Cable cover screw (2x)
Wall bracket
Bracket adjustment screw
Access the video stream,
on page 16. See
Page 9
on page 15