Repairs; Environmental Temperature; Power Supply - Medion AKOYA P54037 Bedienungsanleitung

4.3. Repairs

• Repairs to your monitor should only be carried out by qualified specialists.
• if a repair must be carried out, please contact only our authorised service partner.

4.4. Environmental temperature

• The monitor can be operated at an ambient temperature of +0°C to +35°C with a relative humid-
ity of < 80% (non-condensing).
• When switched off, the monitor can be stored at temperatures from -20°C to +60°C.
DANGER!
After transporting the monitor, wait until the appliance has reached room temperature
before switching it on.
Large changes in temperature or fluctuations in humidity can cause moisture build-up
within the monitor due to condensation. This can cause an electrical short-circuit.

4.5. Power supply

DANGER!
Even when the mains switch is off, some components of the device are live. In order to
disconnect the power to your monitor or to completely isolate the device from voltage
sources, remove the mains plug from the mains socket.
• Operate the monitor only at a 100–240 V~ 50/60 Hz earthed safety contact socket. Contact your
electricity provider if you are not sure if the socket is earthed or not.
• For extra safety, we recommend using an overvoltage protection device to prevent your monitor
from sustaining damage as a result of power surges or lightning strikes.
• To disconnect the power supply from your monitor, pull the mains plug from the power outlet.
• The power outlet must be close to the monitor and easy to access.
• To prevent non-permissible heating up, do not cover the mains adapter.
• The socket must be close to the monitor and easy to access.
• Position the cable so that it cannot be stepped on or tripped over.
• To avoid damaging the cable, do not place any objects on it.
• Please note: The standby switch of this device does not cut it off from the mains completely. The
device also consumes power in standby mode. In order to disconnect the device completely
from the power supply, pull the mains plug out of the power outlet.
• Keep the device at a distance of at least one metre from sources of high-frequency or magnetic
interference (televisions, loudspeaker, mobile telephones, etc.) to avoid malfunctions and data
loss.
• Despite the most modern production methods as a result of the highly complex technology, in
rare cases there may be individual or multiple pixel drop-outs (dead pixels).
26 of 42