Klarstein 10032061 Bedienungsanleitung Seite 22

EN
22
4 In working condition, press SETTING key enter into temperature setting.
(a) Temperature setting: Press SETTING key, the temperature indicator light [°C] will
be on, the LED light in the display will flicker per 0.5 second. You can change
the temperature by pressing [+] or [-] key. The range of the temperature is from
5~35°C, the temperature will be added or minus 1°C every press.
b) After entering temperature setting, the temperature that has been set before will
not be changed. You can reset the temperature, only when pressing [+] or [-]
key. Press SETTING key to quit temperature setting, and the temperature that
you have set will be effect at once.
c) If no operation to the keys after 5 seconds or press other keys except SETTING
and [+]/[-], then the LED indicator will show t the room temperature. When
the room temperature is less than -10°C, display shows [LO], when then room
temperature is over 40°C, it shows [HI].
e) The device will not judge the temperature within 10s when power on the
device. After the device work for 10s, if the ambient temperature 2°C higher
than the temperature that has been set, the PTC heating will turn off, the low/
high heating power light will be off. (The rest indicators will not change.) If
the ambient temperature 2°C lower than the temperature that has been set,
the heating function will be on again with the corresponding heating power
indicator on.
5 When setting the time and temperature at the same time, timing,and the room
temperature and timing display interactively, interval is 30 seconds(Timer display
shows for 30 sec, temperature display off Temperature display shows for 30 sec,
timer display off Timer display shows for 30 sec, temperature display off). When
the timing is not set, only display setting temperature.
6 In working condition, press key to shift the product into ECO mode, indicator on.
ECO mode: The default set is 22°C when environment temperature is lower than
18°C, high power heating is on; when environment temperature is higher than
18°C, Low power heating is on. When the temperature reach 22°C, PTC shut
down. Indicator shows room temperature.
7 Continuous electric memory function: Under standby mode, press POWER key
the unit will keep working as the same status as last time setting, except the timing
function.
8 The whole machine working in a continuous mode after 1 minute, the brightness of
the display section should be reduced to 1/3 of the normal brightness, solving the
problem of LED lamp dazzling in night, it will restore the brightness after operation.