Cleaning And Maintenance; Environmental Information - Power Craft 49000 Gebrauchsanweisung

INSTRUCTION MANUAL
Let the drill achieve full speed before applying it
to the item or surface to be drilled.
Do not press the drill too hard. Select a slow drill
speed for large bits or hard materials, and a faster
speed for small bits or softer materials.
Stop the drill by releasing the on/off button.
Good tips for drilling
When drilling smooth surfaces, e.g. tiles, stick a
piece of strong tape on the drill site before drilling
to prevent the bit slipping.
Always punch the drill site when drilling steel.
Place a piece of scrap wood under the item when
drilling thin sheet metal to avoid deforming the
sheet.
Lubricate the drill site with oil when drilling
metal. Use machine oil for steel and paraffin oil for
aluminium.
To avoid splinters when drilling wood, place a
piece of waste timber under the item, or drill from
both sides
For large diameter holes, start with a small
diameter drill and then use the desired diameter.
ENGLISH

Cleaning and maintenance

Wipe the drill using a well-wrung cloth after use,
and always keep the surface and ventilation holes
(4) free of dirt.
Never use corrosive or abrasive detergents, as they
may attack the plastic parts of the machine.

Environmental information

You can help protect the environment!
Follow local environmental regulations:
Dispose of unwanted electrical
equipment at an approved refuse
disposal centre.
17