Beta 1760DGT Handbuch Seite 16

Frequency or Duty Cycle Measurements
1 Insert the black test lead banana plug into the negative COM jack and the red test lead banana
plug into the positive HZ jack.
2 Turn the rotary switch to the Hz % duty position.
3 Press the Hz/% button to select "Hz" or"%".
4 Touch the test probes to the circuit or under test and read the frequency or duty cycle on the display.
Temperature Measurements
1 Insert the type K thermocouple probe black test lead banana plug into the negative COM jack
and the red test lead banana plug into the positive + jack.
2 Turn the rotary switch to the select °C or °F.
3 Read the temperature on the display
Pulse Width Measurements
1 Insert the black test lead banana plug into the negative COM jack and the red test lead banana
plug into the positive + jack.
2 Turn the rotary switch to the Pulse Width position.
3 Connect the back test probe to ground and connect the red test probe to the signal wire that
connects to the component to be measured.
Note : the applied time for most fuel injectors is displayed on the negative (-) slope
RPM (TACH) Measurements
1 Select the RPM range with the rotary switch
16