Operation; Mode Button - Beta 1760DGT Handbuch

OPERATION

Warning: Risk of electrocution. High-voltage circuits, both AC and DC, are very dangerous and
should be measured with great care.
1 Always turn the function switch to the OFF position when the meter is not in use. This meter
has Auto OFF that automatically shuts the meter OFF if 30 minutes elapse between uses.
2 If "OL" appears in the display during a measurement, the value exceeds the range you have selected.
Change to a higher range.
Note: On some low AC and DC voltage ranges, with the test leads not connected to a device, the
display may show a random, changing reading. This is normal and is caused by the high-input sen-
sitivity. The reading will stabilize and give a proper measurement when connected to a circuit.

Mode button

To select DC/AC Voltage, DC/AC current, resistance, diode, continuity and capacitance check.
STROKE 4/2(DIS) Hz.% ms CYL BUTTON. To select STROKE 4/2(DIS) Hz.% ms CYL range
Data hold / Backlight button
The Data Hold function allows the meter to "freeze" a measurement for later reference.
1 Press the DATA HOLD button to "freeze" the reading on the indicator. The indicator "HOLD"
will be appear in the display
2 Press the DATA HOLD button to return to normal operation.
3 If press the BACKLIGHT button 2 seconds, the display lights on
4 Press BACKLIGHT button 2 seconds again to exit the light mode.
13