Declaration Of Conformity Ce; Electrical Connection - Seenergy Rusticana Montageanleitung


The electrical supply of the power network shall be stable and cope with the
indicated electrical standards, 220/240v AC, 50Hz. Should it be not stable and
receive voltage variations in the supply, intensity or frequency such as armonici,
transistor, voltage dips, overloads, electrical storms, etc..., the hood may show
malfunctions or even breakdowns, and the repair would not be covered by the
warranty. In that case, the exhaust hood shall be disconnected and the company
must contact an electrician or electrical company in order to solve the supply
problem.

The exhaust hood is a household appliance fit to a un elettrodomestico atto
all'estrazione di fumi, non può essere utilizzata come elemento di sostegno di
oggetti o utensili.

In the constant effort to to improve our products, we reserve the right to make
changes following their enhancement to their technical, functional and aesthetic
characteristics.

Declaration of Conformity CE

This appliance is in compliance with the following European Directives: 93/68/CE :
General regulations - 2006/95/CE : Concerning low tensions - 89/336/CE :
Electromagnetic compatibility - CE Regulation n° 1935/2004: this appliance is suitable
to come in contact with food products.

Electrical Connection


Before connecting the appliance to the electricity supply, check that the voltage
corresponds to that on the data plate and that the power supply cable is suitable
for the appliance load also stated on the data place.

If the appliance is connected directly to the mains, fit an all-pole disconnect switch
with minimum contact gap of 3 mm, adequate for the appliance load and
complying to regulations.

The plug used must support the power of work of the appliance.
- Do not use reducers, adapters or switches for connection to the mains, since these could
overheat and cause burns
- Earth connection is required by law
WARNINGS
EN/3