Cleco mPro400GCD-P Programmieranleitung Seite 20

P2300HW-EN
2018-03
X9, X10 – Input/Output
The required signal circuits are connected to these input/output connectors. The signal groups are not gal-
vanically connected to the power supply; galvanic isolation is required.
• 16 digital inputs/outputs, optically isolated for 24 V level/0.5 A
• 8 inputs/8 outputs/2 +24 VDC/2 GND
• Output current: 500 mA per output, 2000 mA total
A single device must not require a current of more than 500 mA. The current monitor switches off the

ATTEN-
output in the event of an overcurrent.
TION!
Pin Signal X9
12 GND-int
11 GND I/O0–3
10 Output O3
9 Output O2
8 Output O1
7 Output O0
6 Input I3
5 Input I2
4 Input I1
3 Input I0
2 +24 VDC A0–A3
1 +24 VDC-int
Connectors that use an internal 24 V power supply
(Primary, Master)
Inputs
• Internal 24 V power supply for the controller.
• Pin 11 and 23 (common GND) serve as a "return line" for the outputs.
• Pin 11 and 23 must be connected to Pin 12 or 24 with jumpers.
Outputs
• Internal 24 V power supply for the controller
• Pin 2 and 14 (common output) are the voltage source for the inputs.
• Pin 2 and 14 must be connected to Pin 1 or 13.
EN
Pin Signal X10
24 GND-int
23 GND I/O4–7
22 Output O7
21 Output O6
20 Output O5
19 Output O4
18 Input I7
17 Input I6
16 Input I5
15 Input I4
14 +24 VDC A4–A7
13 +24 VDC-int
20
2x12 pin Phoenix MCD 0.5/24-G1-2.5
Order No. S981211
X9
Mating connector
Phoenix FK-MC 0.5/12-STZ3-2.5
Order No. S981211
X10