Notes On This Hardware-Description; Safety; General Requirements - Cleco mPro400GCD-P Programmieranleitung

P2300HW-EN
2018-03
1
Notes on this
Hardware-Description
The original language of this description is German.
This description is intended for all persons who connect
and install the controller. The software that is used is not
the subject of this description.
You can find further documents
No. Document type
P2279SB System handbook
P3268C EC Declaration of Conformity
Symbols in the text
Denotes menu options, e.g.,Diagnostics
Italic
> Denotes the selection of a menu option from
a menu, e.g., File > Print
<...> Denotes switches, pushbuttons or the keys
of an external keyboard, e.g., <F5>
Denotes input fields, check boxes, radio but-
Courier
tons or dropdown menus.
Denotes filenames and paths, e.g.,
setup.exe
/ Acts as a separator for the subdirectories in
a file path, e.g., File/Print (operating
system OS9)
• Denotes lists
Denotes instructions that must be followed

EN
2

Safety

2.1

General requirements

Only operate the controller after you have read this and

fully understood this document. Failure to follow the
directions and safety instructions could result in electric
shocks, burns and/or serious injuries.
Keep this document in a safe place for future use!

These safety instructions must be accessible to the
operator at all times. They must be presented and
made accessible to all persons using or repairing the
device.
Intended use
The product is a part of the Cleco Production Tools tighten-
ing system and is intended exclusively for industrial use in
fastening processes. Only use the nutrunner controller
under the following conditions:
• in conjunction with the components listed in the EC
Declaration of Conformity P3268C.
• Only operate the mPro400GCD-S (H) -STO nutrunner
controller in conjunction with the mPro400GCD-P Pri-
mary or mPro400GCD-M Master.
• under the prescribed environmental conditions; see the
relevant documentation
• with the permissible supply voltage
• within the power range, which is specified in the techni-
cal data
• in EMC Limit Class A (electromagnetic immunity for
industrial areas). For the currently observed EMC stan-
dards, see the EC Declaration of Conformity.
Predictable misuse
Do not use the nutrunner controller:
• in potentially explosive areas
• in damp spaces/outdoors
• in connection with cutting tools (drills, milling cutters,
grinders...)
• in the non-industrial sector (eg residential area)
• for other drive tasks than screwing with the components
mentioned in the declaration of conformity.
• The bridging of safety devices is inadmissible.
14