Accept Configuration - Miele XKM 3000 L Med Montageanweisung

en - Configuring the interface
Accept configura-
tion
44
The following display is an example of entering
mask
etc.:
The current setting is shown in the middle line. This can be altered
using the options shown in the bottom line. The top line shows the
selected option. The following input options are available:
– Numbers from 0
.
– Decimal point " ".
– Use the  symbol to delete the last position.
OK
– Use the symbol to save your setting. The display will then return
to the main menu.
– The  symbol in the display or the  button end the process
without saving the setting. The display reverts to the initial menu.
IP address
Always enter the
IP address
stance if the
192.168.001.023
.
Use the arrow buttons  (right) and  (left) to move the cursor to

the option you require.
Confirm each entry with OK.

Save your settings by selecting the

then confirm your choice with the OK button.
The interface configuration is only effective after the washer-disin-
fector has been restarted.
Wait approx. 10 seconds before switching the washer-disinfector

off for a restart.
Switch the washer-disinfector off and then back on again with the

 button.
Wait approx. 90 seconds for the module to initialise.

Then carry out a functional test of the interface.

IP address
to 9 .
Subnet mask
, the
is 192.168.1.23 you must enter
OK
IP address Subnet
,
etc. fully. For in-
symbol in the display and