Check The Connection Status; Selecting Settings - Miele XKM 3000 L Med Montageanweisung

Check the con-
nection status

Selecting settings

Module status
Select the

Active
One of the following messages may appear in the display:
Active
–
The module is ready for operation.
Initialising, module not yet active
–
The module has not finished initialising. This process takes approx.
90 seconds.
Inactive
–
A module has not be recognised.
Check the module installation. Switch the washer-disinfector off
and then back on again.
If the message appears in the display again call Miele Service.
Document all settings in case of a subsequent Service call require-
ment.
For manual entries DHCP must first be deactivated.
Select the DHCP option and confirm your choice with OK.

DHCP
On
Off
Off
Select the option and confirm your choice with OK.

The following settings are then available:
IP address
–
Subnet mask
–
Standard gateway
–
– DNS server automatic
DNS server 1
–
DNS server 2
–
Port type
–
Port
–
Select an option and confirm your choice with OK. You can then

carry out settings as shown in the display.
en - Configuring the interface
option and confirm your choice with OK.
43