Klarstein 10030517 Bedienungsanleitung Seite 10

Fit the paddle into the power unit until locked into
place.
Step 5
Insert the plug into outlet. Now you can switch on the ice cream maker using the on/off switch. THE MACHINE
MUST BE SWITCHED ON BEFORE ADDING THE ICE CREAM OR SORBET RECIPE TO PREVENT THE MIX
FROM IMMEDIATELY FREEZING ON THE INSIDE OF THE BOWL.
Step 6
Pour the ice cream or sorbet mix into the freezer bowl from lid. When pouring mixture into the bowl, always
stop at least 1 inch from the top, as the mixture will increase in volume during freezing.
Step 7
Allow the mixture to churn until frozen or the desired consistency is reached. This can take up to 30 minutes,
but most recipes will be ready in less time.
Important Notes on Use
• Do not stop and start the machine during the freezing process, as the mixture may freeze in contact with the
bowl and prevent movement of the paddle.
• To avoid overheating the motor, the direction of rotation will change if the mixture becomes too thick. If the
direction of rotation continues to change, stop the machine when the mixture is ready.
• In the unlikely event of the motor overheating, a safety cut out will operate causing the motor to stop. If this
happens, unplug the machine and allow the power unit to cool.
• For the best result of ice cream, the paddle will contact with the inside of the inner bowl when the paddle
moves.
• When the setting time is over, the machine is stopped automatically, unplug the machine and remove the
power unit/lid. The ice cream is ready to serve.
Step 3 Step 4
Take out the freezer bowl from the freezer. Lower the
assembled lid/power unit/paddle onto the freezer
bowl and turn clockwise to lock into position.
10