HP LaserJet 3330mfp Faxhandbuch Seite 41

Problem
The product is receiving
faxes but is not sending
them (continued).
Outgoing fax calls keep
dialing.
Faxes you send are not
arriving at the receiving
fax machine.
You cannot dial all of
the numbers in a long
fax number.
ENXC
Cause
Your phone line might not be
working.
The product will automatically
redial a fax number if the
redial on busy option is set to
on.
The receiving fax machine
might be off or have an error
condition, such as being out
of paper.
A fax might be in memory
because it is waiting to redial
a busy number, there are
other jobs ahead of it waiting
to be sent, or the fax is set up
for a delayed send.
The maximum number of
digits or characters that can
be entered into a fax number
is 50.
Solution
Do one of the following:
Turn up the volume on the
product and press fax/send on
the control panel. If you hear a
dial tone, the phone line is
working.
Disconnect the product from
the phone jack and connect a
phone. Try to make a phone
call to make sure the phone
line is working.
To stop the redials while the
product is dialing, press Cancel.
See the redial topic in the
electronic user guide if you need to
change the setting.
Call the recipient to make sure the
fax machine is on and ready to
receive faxes.
If a fax job is in memory for any of
these reasons, an entry for the job
appears in the fax log. Print the fax
activity log (see "Printing the fax
activity log" on page 28) and check
the Status column for jobs with a
Pending designation.
Try dialing the fax number in
manual mode. See "Using manual
dial" on page 28.
Sending fax problems 39