Off-Season Storage; Repair - Zgonc yellow gardenline 720 YGL N.G. Originalanleitung

Off-Season Storage

m
Refer to the Engine Manual for information on storing your engine.
At the end of the season or if the snow thrower will not be used for 30 days or longer, follow the storage instructions below.
1. Run the engine until the fuel lines and carburetor are empty and it stops due to lack of fuel.
2. Remove the safety ignition key and allow the engine to cool.
3. Lubricate the machine as instructed.
4. Clean the exterior of the engine and the snow thrower thoroughly.
5. Touch up all rusted or chipped paint surfaces; sand affected areas before painting, and use a rust preventative to prevent the metal
parts from rusting.
6. Tighten all loose screws, bolts, and locknuts. Repair or replace any damaged parts.
7. Cover the machine and store it in a clean, dry place out of the reach of children.
Generel lubrication
Lightly lubricate all moving parts of the machine at the end of the season or every 20
operating hours.
m
Do not allow grease or oil get on friction disc, friction plate or belts. Do not exces-
sively oil the machine; extra oil may enter the traction drive and cause the traction
drive belt to slip.
When lubricating auger shaft, remove shear pins to apply oil inside the shaft and
around spacers and flange bearings found at either end of the shaft.
Remove the wheels to apply grease the wheel shaft.

Repair

Feed screw belt
If the auger belt becomes worn, oil-soaked, or otherwise damaged, proceed as follows
to replace the belt.
1 In order to prevent spillage, remove the fuel from the tank by closing the fuel valve
and running the engine until it stops. Then, open the tank cap and let the petrol
completely drain into a sufficiently large container by tilting the machine or sucking
it out. Then, close tank cap again.
2 Remove the two screws that hold the belt cover in place and set the cover asid
3 Roll the auger belt(s) off the engine pulley.
51
D GB