Adjustments - Zgonc yellow gardenline 720 YGL N.G. Originalanleitung

D GB
Track Lock Lever (if so equipped)
Transport
The track lock lever is used to select the position of the auger housing and the method
Normal
of track operation. Move the lever to the right then forward or backward to one of the
three positions.
Tieffräsen
Transport – Raises the front end of the snow thrower for easy transport. Using proper
caution, this position may also be used on many gravel driveways to clear snow while
leaving gravel undisturbed.
Normal – Allows the tracks to be suspended independently for continuous ground
contact.
Deep Cutting – Locks the front end of the snow thrower down to the ground for had-
packed or icy snow conditions.

Adjustments

Skid Shoes
Position the skid shoes based on surface conditions. For removal of snow in normal
conditions, such as a paved driveway or sidewalk, place skid shoes in the higher posi-
tion to give a 3mm (1/8") clearance between the scraper blade and the ground. Use a
middle or lower position when the area to be cleared is uneven, such as a gravel
driveway.
m
It is not recommended to operate the snow thrower on gravel as it can easily
pick up and throw by the impeller, causing personal injury o damage to the snow
thrower and surrounding property.
If you choose to operate the snow thrower on a gravel surface, use extra caution and
keep the skid shoes in position for maximum clearance between the ground and the
scraper blade.
m Always adjust skid shoes after adjusting scraper blade to prevent premature wear
to scraper blade or damage to auger housing.
To adjust the skid shoes:
1. Loosen the four hex nuts (two on each side) and carriage bolts. Move skid shoes
to desired position.
2. Make sure the entire bottom surface of skid shoe is against the ground to avoid
uneven wear on the skid shoes.
3. Retighten nuts and bolts securely.
46