Zgonc yellow gardenline 720 YGL N.G. Originalanleitung Seite 40

D GB
2 After the shift rod with a flat washer has been inserted through the hole in the shift
arm, add the other flat washer on the shift rod, and secure with a clevis pin.
3 Lift up on the shift rod. Loose the jam nut under the trunnion and thread the trun-
nion along the shift rod until it fits into the hole in the shift lever. Tighten the jam nut
and Install washer and M8 nut. Tighten securely.
Shaft cleaning tool
Fasten the shaft cleaning tool in the retaining clip located on the rear side of the feed
screw housing.
Replacement Shear Pins
A pair of replacement auger shear pins and clevis pins are included with your snow
thrower. Store them in a safe place until needed.
Spare Roll Pins
The impeller is secured to the impeller shaft with roll pins.
Two 6x37 roll pins for impeller are supplied as spare in the hardware bag. Store them in
a safe place until needed.
40