Beyerdynamic UNITE TP Kurzanleitung Seite 25

Unite TP – Bodypack Transmitter
display an error (see table). Alternatively, you can
connect the transmitter to the USB port on the
charger via a USB cable.
3. Insert one or more receivers into the charging slots
of the charger to be paired with the transmitter. You
can also connect another receiver to the charger
using the USB port. Remove all receivers that should
not be paired. If there is no receiver in the charging
slots, the pairing information is stored in the charger.
This is used for later pairing without connecting the
transmitter to the charger.
4. In order to transfer the pairing information from the
transmitter to the receivers in the slots and to the
charger itself for future pairing, press and hold the
"Pair/Reset" button
2 seconds. The status indicator
several seconds if the pairing is successful. The
status indicator will then remain yellow because the
pairing information is now also stored in the charger.
5. If you want to pair other receivers, remove the trans-
mitter and all receivers from the charger, set the
switch
receivers into the charger. The pairing information
will be stored immediately in the unpaired receivers.
The status indicator on the receiver will flash yellow
rapidly while this happens.
6. Set the switch
pairing is finished, so that the charger can only be
used for recharging.
7. Switch on the transmitter and one receiver to check
that they have both been paired successfully.
After a few seconds, the status indicator
on the charger for more than
to "Pair & Charge" and insert the unpaired
back to "Charge only" when the
will flash yellow for
on the
25