AEG LAVATHERM 87685DIH Benutzerinformation Seite 22

22 www.aeg.com
Problem
Unsatisfactory
drying result.
The loading
door does not
closed
Err (Error) on
the display.
No drum light
Abnormally
elapsing time on
the display.
Programme in-
active.
Possible cause
1)
Incorrect programme selection.
The filter is clogged.
The Dry Plus (Drogen Plus) option
was in minimum level.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the humidity sensor in the
drum.
Incorrect remaining laundry mois-
ture degree.
The heat exchanger is clogged.
The filter not locked in the posi-
tion.
The laundry is locked between the
door and the seal.
You try to change the programme
or the option after the start of the
cycle.
The option you try to activate is
not applicable with the selected
programme.
Defective drum lamp.
The time to end is calculated on
the basis of the volume and damp-
ness of the laundry.
The water container is full.
Do the selection of the applicable
programme.
Clean the filter.
Change the Dry Plus (Drogen Plus)
option to the moderate or maxi-
4)
mum level.
Obey the maximum load volume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust remaining laundry moisture
degree.
Clean the heat exchanger.
Put the filter in the correct posi-
tion.
Put the load correctly in the drum.
Turn the tumble dryer off and on.
Make the new selection.
Turn the tumble dryer off and on.
Make the new selection.
Contact the service centre to re-
place the drum lamp.
The automatic procedure — this is
not the appliance malfunction.
Drain the water container, push
the Start/Pause (/Pauze) button.
Remedy
2)
3)
4)
5)
3)
3)