Commissioning - SXT NEO Benutzerhandbuch

E
Fold up the scooter and assemble the handle
1. Place the scooter on the ground, push the flap / cover together while Pull the handlebar up slightly. (see image)
①
2. Hold the stem by hand and pull it up until it is vertical to the ground and you hear a click. The click means the switch is reset.
3. Tighten the handlebar clockwise, and tighten two nuts in the left and right handlebars with a 3 mm inner hexagon spanner as
shown below.
4. Fully charge your SXT scooter before driving.
Wichtige Hinweise

Commissioning

②
After installation, test the start/stop. Each scooter has the factory default gear 1.
1.Keep pressing power switch, when it beeps, it means turn on.
2.Double-click the power swith to change the gear.
③
2 6 2 6