BESAFE iZi Modular i-Size base Gebrauchsanweisung Seite 3

10
5. When installing in the front seat of the vehicle, adjust the back rest
into an upright position. (12)
6. If your vehicle is not equipped with ISOfix insertion clips, insert
these to make installation easier. (13)
7. ISOfix insertion clips are underneath the base.
8. When the base is lifted the floor support should fall downwards
from underneath the base. Do this outside the car. (14)
9. Push down one of the grey ISOfix releases on top of the base. The
ISOfix connectors will appear at the back of the base. Pull the ISOfix
connectors fully out. (15)
10. Position the base on the vehicle seat. Click the ISOfix connectors on
to the ISOfix points on the vehicle seat. Make sure that both ISOfix
indicators are green. (16)
11. During installation, you can prevent the ISOfix connectors from
sliding in, by pushing at least on one side on the marked area in
front of the grey isofix release switch. (16)
12. Push the base against the backrest of the vehicle seat until it is
firmly in place. (17)
13. Remove the yellow cap from the floor support. The alarm sound will
stop when the seat is installed correctly with the floor support in
contact with the floor of the vehicle. (18)
14. Adjust the floor support, so it is in contact with the floor of the
vehicle. (19)
15. The height indicator of the floor support shows green when the
floor support is in contact with the floor. (20)
16. The alarm sound stops when the floor support indicators show
green and it is in contact with the floor. (20)
Removal of the base from the vehicle
1. To remove the base from the vehicle, you have to slide the
central grey ISOfix release switch towards the front. Both isofix
connectors will release from the vehicle
2. If removal is difficult, it can help to push the base towards the
backrest of the vehicle, while pulling the ISOfix release switch.
! Warning: potential misuse
• The child seat MUST NOT be installed in a front
passenger seat WITH AN ACTIVATED AIRBAG.
• The floor support must always be used. Make sure that
the floor support is fully pushed down.
• When used in combination with iZi Modular the front brace must
be fitted on the base.
• Make sure the indicators are green before you drive.
Guarantee
• Should this product prove faulty within 24 months of purchase
due to materials or manufacturing fault, except covers and harness
straps, please return it to the original place of purchase.
• The guarantee is only valid when you use your seat appropriately
and with care. Please contact your retailer, they will decide if the
seat will be returned to the manufacturer for repair. Replacement
or return cannot be claimed. The guarantee is not extended
through repair.
• The guarantee expires: when there is no receipt, when defects are
caused by incorrect and improper use, when defects are caused by
abuse, misuse or negligence.
11