Ideen Welt RFC-0902 Bedienungsanleitung Seite 25

Step 4 - Top of the head
1. Use a cutting length of approx. 8 mm to 12 mm.
2. The hair on top of the head should be cut against the growth direction. This
means from front to back. However, in some places it may be necessary to cut
the hair from back to front.
3. If you would like to achieve a short hair or brush cut, use a cutting length of
approx. 4 mm to 8 mm.
Cutting hair using the comb (without an attachment comb)
1. Using the comb or your fingers, lift the hair to be cut and cut it with the clipper
above the hair to the desired length. Always cut the hair at the back of the
head first. The cutting length can be determined by decreasing or increasing
the distance of your fingers or the comb to the head.
2. Remove cut hair from the comb regularly and inspect the evenness of the cut.
Afterwards trim hair that is too long.
Step 5 - Final touches
1. Use the hair clipper without an attachment comb for the final touches. Touch
up the contours on the sides of the neck and around the ears.
2. In order to cut sideburns straight, hold the hair clipper with the blades facing
down.
3. Place the cutting blade onto the skin at a right angle and cut downwards.
Brush cut, short hair cut and crop cut
1. Set the cutting length to 20 mm. Cut from the base of the neck to the crown of
the head. Hold the attachment comb flat against the head and move it slowly
over the hair.
2. Repeat this step from the base of the head to the top. Now cut the hair from
the forehead to the crown and even out the cut on both sides.
3. For a crop cut, it is recommended to use the attachment comb for cutting the
hair on the top of the head. You can achieve better results than if you do not
use an attachment comb.
4. Finally, use the smallest cutting length (4 mm) in order to give the hair a
brush-form down to the base of the neck. Then check to make sure the haircut
is symmetric. Touch-up the haircut afterwards if necessary. The last step is
cutting the side burns as well as shortening the hairs at the base of the neck.
Beard Trimming
To trim a beard, put on the attachment comb for the desired length and cut the
beard hair accordingly. Always cut the beard hair with an attachment comb first.
To touch up the cut, the hair clipper may also be used without an attachment
comb.
RFC-0902_A6_160726.indb 25
25
26/7/16 12:14 PM