Charging The Battery; Cutting Hair - Ideen Welt RFC-0902 Bedienungsanleitung

CHARGING THE BATTERy

• As soon as the performance of the beard and hair clipper becomes reduced,
it must be recharged again. The performance is reduced when the motor runs
noticeably slower.
• The device must be switched off to recharge.
• Recharge the battery as described in the section Prior to First Use. The normal
charging time is 8 hours. In order to preserve the battery, do not exceed the
recommended charging time.
• When fully charged, the clipper can be operated for approx. 45 minutes.
• The battery should not be recharged when the ambient temperature is under
0 °C or over 40 °C.
• The battery should also not be charged when the device is located right next to
heat-producing devices and equipment or when it is exposed to direct sunlight.

CUTTING HAIR

INFORMATION TO MECHANICALLy CUTTING HAIR:
General Information
Before you begin to cut the hair:
1. Inspect the hair clipper prior to each use. There should not be any dirt build-up
in between the blades and the lubricating oil must be distributed evenly over
the blades so that proper functioning can be ensured. Excessive lubricating oil
should be wiped off prior to using the clipper.
2. The person whose hair is being cut should sit at eye height to you in order to
ensure better control of the hair clipper. This also prevents muscle cramps and
unnecessary strain for the user of the hair clipper.
3. Comb the hair thoroughly before cutting.
4. Place a cape over the shoulders of the person whose hair is being cut.
Thinning function
1. Slide the button to "
2. Only the hairs which the blade touches will be cut.
3. Slide the button to "
RFC-0902_A6_160726.indb 23
". The blade is covered partly.
" to turn off the thinning function.
23
26/7/16 12:14 PM