Intended Use - Makita DUC204 Betriebsanleitung

Saw chain type
Number of drive links
Guide bar
Sprocket
NOTICE:
When using 25AP saw chain, use with Sprocket 9 (optional accessory).
WARNING:
Use appropriate combination of the guide bar and saw chain. Otherwise personal injury may
result.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
Wear ear protection.
Wear a helmet, goggles and ear protection.
Use appropriate protection for foot-leg and
hand-arm.
This saw is to be used by properly trained
operators only.
Do not expose to moisture.
Maximum permissible cut length
Always use two hands when operating the
chain saw.
Direction of chain travel
Saw chain oil adjustment
Only for EU countries
Ni-MH
Li-ion Do not dispose of electric equipment or battery
pack together with household waste material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.
Guide bar length
Cutting length
Pitch
Gauge
Type
Number of teeth
Pitch

Intended use

The tool is intended for cutting branches and pruning
trees. It is also suitable for tree service.
Noise
The typical A-weighted noise level determined accord-
ing to IEC62841-4-1:
Model DUC204
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Model DUC254
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
Model DUC254C
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.5 dB(A)
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to IEC62841-4-1:
Model DUC204
Work mode: cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DUC254
Work mode: cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DUC254C
Work mode: cutting wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration emission value may
also be used in a preliminary assessment of exposure.
9 ENGLISH
25AP
60
250 mm
250 mm
1/4"
1.3 mm
Carving bar
9
1/4"
) : 92.2 dB(A)
pA
) : 103.2 dB (A)
WA
) : 92.2 dB(A)
pA
) : 103.2 dB (A)
WA
) : 92.2 dB(A)
pA
) : 103.2 dB (A)
WA
2
) : 3.1 m/s
h,W
2
2
) : 3.1 m/s
h,W
2
2
) : 4.1 m/s
h,W
2