Troubleshooting; Legal Notice - Technotherm International HR DREAM Installations- Und Bedienungsanleitung

10. Troubleshooting

• In the event of overheating, the safety device on the appliance automatically disabled the heating elements and
motor. In this case:
- Turn off the fan heater and allow it to cool down for about 15/20 minutes.
- Make sure the dust filter is not totally obstructed and clean if necessary. Remember to put it back again
afterwards.
- Eliminate any other possible reasons for overheating (e.g.: obstructions in front of the air inlet/outlet grilles,
build-ups of dirt).
- Turn on the fan heater again and check it works correctly.
• If the touch control commands are blocked or don't properly answer to digital pressure, turn off the heater using
the electromechanic switch on the left side of the heater. Then turn on the heater using the same switch.
11. Maintenance
• This product does not require any special maintenance.
• Clean the product with a dry cloth once every 6 months.
• If the product requires repairing, contact an authorised technical service centre.
• When replacing the power cable, use a 2x1,00mm2 H05VV-F HAR type. This operation must be performed
by qualified personnel and never by the end user in order to avoid damaging the appliance and jeopardising
personal safety.

12. Legal notice

Environment and recycling
Please help us to protect the environment by disposing of the packaging in accordance with the national
regulations for waste processing.
Recycling of obsolete appliances
Appliances with this label must not be disposed off with the general waste. They must be
collected separately and disposed off according to local regulations.
Feel good through warmth from electricity - www.technotherm.de