Herunterladen Inhalt Inhalt Diese Seite drucken

Technotherm International HR DREAM Installations- Und Bedienungsanleitung Seite 28

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

8. Using the fan heater
MAIN ON/OFF SWITCH (placed on the right side of the product)
The power supply of the product is controlled by an electromechanical ON/OFF switch. Switching off the fan heater
will cut off the power to the electronic board and this will cause the loss of every stored information, after 30 minutes
of absence of the power supply. We recommend to use this switch only when you are not using the product for long
periods and instead to use the on / stand-by control for any short-term interruptions. In this way you will not lose the
stored settings.
For the first use of the product or in case of power loss for over 30 minutes, when on ON position, the display shows
00:00 and begins counting the time starting from this value.
STAND-BY BUTTON
SETTINGS
The following keys
,
Comfort temperature and to activate or deactivate the open window detection function.
E.g.: To set 08:30, Tuesday, Comfort temperature of 25°C and enable the open window detection previously disabled,
proceed as follows:
00:00
Feel good through warmth from electricity - www.technotherm.de
This is used to switch the product on or put it on stand-by. The LED to the left of the button
is:
- Off, if the product is on stand-by
- Green, if the product is switched on but is not heating up
- Red, if the product is switched on and is heating up
When the product is switched on, it automatically reinstates the operating mode and refe-
rence temperature at the time it was previously switched off (excepting for turbo and towel
warming mode, for which the product switches on again in comfort mode).
If the product is new or there has been a power failure on the mains supply for more than
30 mins, the radiator switches on in comfort mode and the default reference temperature
is 23°C.
and
, will allow you to adjust the current hour and day of the week (1 = Monday), the
Time setting
Activate display / edit by holding the key down
The two hour digits flash.
for at least 3 seconds.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis