Turbo Mode; Lock Function - Technotherm International HR DREAM Installations- Und Bedienungsanleitung

donE
Note:
-At any time you can abandon the procedure for viewing / editing the program deleting unsaved changes by
pressing the Stand-by button;
-During the programming the heating elements are disconnected and the product doesn't heat.

TURBO MODE

• The heater works for the preset period switching on both the front surface heating and the fan heater integrated
at the bottom of the unit. The functioning period can be set choosing between 10, 20,30 and 60 minutes just
pushing repeatedly the Turbo
• The display reads the Turbo function icon, the pilot flame representing that heating is activated and the remaining
functioning time:
• To deactivate the Turbo function just press the

9. Lock function

Feel good through warmth from electricity - www.technotherm.de
When the display reads "donE" for a few seconds, this is confirmation that the procedure
has been completed correctly. The product goes back to the operating state programmed
for the current time and day.
key.
Access the lock function by holding the
It is normal for the time to begin flashing after 3 seconds. Do not remove your finger from
the button until the display reads "LOCK".
To activate the Lock function, push the
The display reads ON and the lock symbol is shown at the bottom of the display:
To deactivate the Lock function, push the
The display reads OFF
Confirm the setting chosen by pushing the
ting mode in progress previously.
ket at any time.
key down for at least 10 seconds.
key.
key.
key . The system goes back to the opera-