Electrolux IK2805SZR Benutzerinformation Seite 17

Problem
The compressor does not
start immediately after
pressing the "FastFreeze"
or "FastCool", or after
changing the temperature.
Water flows inside the re‐
frigerator.
Temperature cannot be
set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastFreeze" or
"FastCool" is switched
on.
The water drainage plug
is not correctly posi‐
tioned.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The "FastFreeze func‐
tion" or "FastCool func‐
tion" is switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion" or "FastCool function".
Position the water drainage
plug in the correct way.
Refer to "Operation" .
The compressor starts after
a period of time.
Make sure that food prod‐
ucts do not touch the rear
plate.
Switch off "FastFreeze func‐
tion" or "FastCool function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"FastCool function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Add less food products at
the same time.
17