Connection - auna 10031404 Bedienungsanleitung

Source Equipment Connections Instructions
1. While connecting, you should switch off power
supply, and after finishing connections, switch on
the unit again.
2. All plus should be inserted firmly, or noise will
be heard.
Source Audio and Video Equipment Connections
Instructions
1. While connecting audio device, you should use
RCA.
2. It should be right, that connecting right speaker
to right output, left speaker to left output.
Speaker Connections Instructions
• The speaker impedance should be correct (read
,.Speaker Choice"), or could damage this unit or
speaker.
• Do not let the bare speaker wires touch each other
or any other metal parts as this could damage this
unit or speakers.
• Make sure the polarity of speaker wires is
correct,,.+-" to,.+-", and .. --" to .. --" if these wires
are observed, the sound will be unnatural and will
lack.
Connecting Speaker System
Connect the speaker terminals to your speakers wire
of proper gauge, cut as short as possible. Cut off the
insulation about 10mm from the wire, if the bare wire
is loose wiring it up.
16

Connection

AUX3
AUDIO IN
10031404
REC.L AUX3 AUX2 AUX1
REC.R AUX3 AUX2 AUX1
IMPEDANCE:4-8Ohm IMPEDANCE:4-8Ohm IMPEDANCE:4-8Ohm IMPEDANCE:4-8Ohm AUDIO OUT AUDIO INPUT
AUX2
AUDIO IN
IMPEDANCE:4-8Ohm IMPEDANCE:4-8Ohm IMPEDANCE:4-8Ohm IMPEDANCE:4-8Ohm
RF
AUX1
AUDIO IN
10031404
REC.L AUX3 AUX2 AUX1
REC.R AUX3 AUX2 AUX1 RF
AUDIO OUT AUDIO INPUT