Putting On/Taking Off Reflector; Screwing The Studio Flash Unit To A Tripod - Metz mecastudio BL-200 Bedienungsanleitung

- Pull out bulb a
- Carefully pull the bulb a out of the
socket.
- If no further flash photographs will
be taken, then put the protective cap
back on.

5.1.3 Putting on/taking off reflector

- Putting on the reflector
- Push release lever back and keep it
held there.
- Plug reflector into the three plug-in
openings on the unit. In the process,
opening for the lamp screen must
point down.
- Twist reflector in a clockwise direc-
tion until you feel it snap into place.
Let go of release lever
- Removing the reflector
- Push release lever back and keep it
held there.
- Twist reflector in a counter-clockwise
direction as far as it will go and then lift
it off the studio flash unit.
- Let go of release lever
- If no further flash photographs are to
be taken, then put the protective cap
back on.
.
.
5.1.4 Screwing the studio flash unit to a
tripod
The tripod must be designed for the
weight and dimensions of the studio
flash unit.
Observe the information in the of the
tripod manufacturer's guide and
compare it to the technical data of the
studio flash unit (see chapter 13).
The tripod must be setup in such a way
that it cannot tip over and cannot slip.
See picture C
- 1. Turn the screws of the tripod holder
counter-clockwise to loosen them.
- 2. Put the tripod holder
flash unit onto the tripod.
- 3. Tighten the screws of the tripod hol-
der in a clockwise direction.
- 4. Turn screw of the tripod holder
of the studio flash unit counter-
clockwise to loosen it.
- 5. Tilt the studio flash unit to the
desired tilt position.
- 6. Tighten screw for the tilt of
the studio flash unit in a clockwise
direction.
of the studio
k
67