Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety Warnings
• This locomotive is to be used only with an operating
system designed for it.
Use only transformers rated for your local hosehold
!
power. Do not under any circumstances use trans-
formers rated for 220 volts or 110 volts
• Pay close attention to the safety warnings in the
instructions for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
74046 interference suppression set is to be used for
this purpose.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Märklin have been installed
in Märklin products or where Märklin products have been converted in
such a way that the non-Märklin parts or the conversion were causal to the
defects and / or damage arising. The burden of presenting evidence and
the burden of proof thereof, that the installation of non-Märklin parts or the
conversion in or of Märklin products was not causal to the defects and / or
damage arising, is borne by the person and / or company responsible for
the installation and / or conversion, or by the customer.
WARNING! This product contains magnets. Swallowing more than one
magnet may cause death in certain circumstances. If necessary, see a
doctor immediately.
10
Setting Locomotive Parameters with the Control Unit
1. Requirement: Setup as in diagram on page 37. Only
the locomotive to be changed can be on the track.
2. Press the "Stop" and "Go" at the same time until
"99" blinks in the display.
3. Press the "Stop" button.
4. Enter the locomotive address „80".
5. Hold the control knob in the reverse direction area.
While holding the control knob here, press the „Go"
button.
6. The headlights on the locomotive will blink slowly. If
they don't, repeat Step 2.
7. Enter the register number for the parameter to be
changed (=> List on page 38).
8. Active the change of direction.
9. The headlights will blink rapidly.
10. Enter the new value (=>List on page 38).
11. Active the change of direction.
12. The headlights will blink slowly (exception: factory
reset)
13. Enter the next parameter setting from 6 or end with 14.
14. End the process by pressing the „Stop" button. Then
press the „Go" button.
Werbung
