Explanation Of Functions - Becker Centronic MemoControl MC511 Montage- Und Betriebsanleitung

Slide switch
Each Centronic radio receiver for roller shutter and blind installations can save
switching times for one UP and one DOWN movement. In the " " operating
mode, this movement is repeated every 24 hours. It does not matter what pos-
ition the slide switch is in when programming the switching time. Any stored
switching times are overwritten.
Programming the run times
1. If necessary, run the roller shutter or blind to the opposite limit position.
2. Wait for the time you wish the automatic drive command to be executed.
3. At the desired time, press and hold the relevant direction button until the
drive briefly stops after approx. 6 seconds and then continues to the limit
position.
4. Release the direction button.
The receiver has saved the current time for this direction of travel. Proceed in
exactly the same way with the other direction of movement.
In the slide switch position " ", no automatic drive commands will be ex-
ecuted. The saved run times are retained.
Deleting the run times
When deleting, both run times are always deleted.
To delete the UP and DOWN run time, press the STOP button for 10 seconds.
Acknowledgement is given by a "click click" from the drive, or by a "shift" of
the shading solution.
The run times are now deleted.
Transmission pilot light
A radio signal is indicated by the transmission pilot light lighting up. The trans-
mission pilot light flashes while transmitting if the battery is getting weak. The
transmission strength and the radio range decrease as battery power de-
clines. If the transmission pilot light no longer lights up when a button is
pressed, the battery must be replaced.

Explanation of functions

17 - en